pinion

常见例句

• Why don't you try tightening the pinion nut first?
  你为什么不先扭紧小齿轮的螺帽?
• He is held with his arms pinion together behind his back.
  他被捉住反剪著双臂.
• The two differential - pinion gears mesh with these two side gears.
  两个行星齿轮与这两个半轴齿轮相啮合.
• He is held with his arms pinion together behind his back.
  他被捉住反剪著双臂.
• The bird a broken pinion never soars so high again, but its song is sweeter.
  折翼的鸟永远不能振翅高飞, 但却可以唱出更美妙的歌.
• Unique twin guide bar feature absorbs rack and pinion load and ensures optimum teeth engagement.
  独特的双导杆具有吸收齿条和齿轮负载的特点,确保齿轮之间能够优化啮合.
• Drive pinion to stop collar clearance shall be controlled to OEM specifications.
  驱动器小齿轮到止推卡环的缝隙应控制在OEM的标准之内.
• Install the pinion mate shaft lock screw finger tight to hold shaft during differential installation.
  在差速器安装期间,安装小齿轮配合轴锁螺丝,用手紧固它,以把握住轴.
• Usually, we adopt pinion drive for large mills.
  大型磨机我们通常采用边缘驱动.
• The device can be powered electrical, pneumatic, manual, pinion rotating devices.
  本产品驱动装置可采用电动 、 气动 、 手动 、 伞齿轮转动等装置.
• Push and hold ring gear upward while not allowing the pinion gear to rotate.
  当不准许主动齿轮旋转时,向上推环齿轮,并放牢它.
• Why don't you try tightening the pinion nut first?
  你为什么不先扭紧小齿轮的螺帽?
• Install pinion front bearing, if necessary.
  如需要,安装小齿轮前轴承.
• Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference.
  在传动轴和传动轴轴轭 、 或小齿轮轴轭上作标记, 作安装的参考标志.
• Vendor Shirley Pinion displays her wares in Dade County, Ga.
  乔治亚州戴德县的卖主在展示她的货物.
• The power enters the differential through the drive pinion on the end of the propeller shaft.
  也就是说,驱动力是从传动轴末端的传动齿轮输送到差速器的.
• Check ring gear and pinion gear teeth contact pattern.
  检查环形齿轮齿接触印痕.
• Hold the yoke with Wrench 67 Remove the pinion shaft nut and washer.
  在小齿轮轴轴轭处拆卸万向节扣夹螺栓.
• Remove pinion gears from differential case.
  从差速箱处拆卸主动齿轮.
• The drive pinion is meshed with a large ring gear ring gear revolves with the pinion.
  传动齿轮与一个很大的冠状齿轮啮合,传动齿轮驱动冠状齿轮.
• Pinion by the press of men around them, they are unable to move.
  周围的人群挤压著他们, 使他们动弹不得.
• Worn teeth on ring gear or drive pinion gear.
  环形齿轮或驱动小齿轮上齿磨损.
• End play in drive pinion bearings.
  驱动小齿轮轴承的端隙.
• The design of drive shaft is rational in mill system of pinion drives.
  边缘传动式磨机系统的传动轴的设计是合理的.
• The rack and pinion power steering gear of rotary valve has been widely the car.
  现代轿车多采用转阀式齿轮齿条液压动力转向器.
• These four pinions act as bridges between the side gears.
  这四组小齿轮起到连接侧方齿轮组的桥梁作用.
• Drive pinion to stop collar clearance shall be controlled to OEM specifications.
  驱动器小齿轮到止推卡环的缝隙应控制在OEM的标准之内.
• Install the pinion mate shaft lock screw finger tight to hold shaft during differential installation.
  在差速器安装期间,安装小齿轮配合轴锁螺丝,用手紧固它,以把握住轴.
• Why don't you try tightening the pinion nut first?
  你为什么不先扭紧小齿轮的螺帽?
• Install pinion front bearing, if necessary.
  如需要,安装小齿轮前轴承.
• Traction Axis with 2 motors, 2 pinions, rack and clearance electronic take up.
  牵引轴配备两台电机, 两个小齿轮, 台架以及电子设备安装空间.
• Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference.
  在传动轴和传动轴轴轭 、 或小齿轮轴轭上作标记, 作安装的参考标志.
• Rotate the pinion yoke three or four times.
  旋转小齿轮轴轭三次或四次.
• Table 1 gives the fatigue yaw moment exerted on the 4 yaw pinions.
  表1给出了施加在四个偏航小齿轮上的疲劳偏航力矩.
• Hold the yoke with Wrench 67 Remove the pinion shaft nut and washer.
  在小齿轮轴轴轭处拆卸万向节扣夹螺栓.
• Both gear centers have pinions with only half tooth.
  两个齿轮其中心都有一个小齿轮,这个小齿轮只有半边有齿轮.
• If the pinion rotates about a fixed axis, the rack will move in a straight path.
  如果小齿轮绕固定轴转动, 齿条则沿直线运动.
• Worn teeth on ring gear or drive pinion gear.
  环形齿轮或驱动小齿轮上齿磨损.
• End play in drive pinion bearings.
  驱动小齿轮轴承的端隙.
返回 pinion