SerialPort

常见例句

Specifies the parity bit for a SerialPort object.
指定SerialPort对象的奇偶校验位。
Specifies the number of stop bits used on the SerialPort object.
指定在SerialPort对象上使用的停止位的数目。
Represents the method that will handle the serial pin changed event of a SerialPort object.
表示将处理SerialPort对象的串行管脚更改事件的方法。
Specifies the control protocol used in establishing a serial port communication for a SerialPort object.
指定为SerialPort对象建立串行端口通信时使用的控制协议。
Because the SerialPort class buffers data, and the stream contained in the BaseStream property does not, the two might conflict about how many bytes are available to read.
由于SerialPort类会缓冲数据,而BaseStream属性内包含的流则不缓冲数据,因此二者在可读字节数量上可能会不一致。
The following code example demonstrates the use of the SerialPort class to allow two users to chat from two separate computers connected by a null modem cable.
下面的代码示例演示如何使用SerialPort类以允许两位用户分别在两台通过NULL调制解调器电缆连接的独立计算机上聊天。